Onurguzel.com Website Review

this is the story of how i saved my nas from not getting ip address. i have been using iomega hmnhd-ce for 4 years. but it has been heavily modified tough. i replaced the 1 tb drive inside the nas with a 3 tb disk. moreover, instead of installing the stock firmware to the new iface eth0 inet dhcp     pre-up ifconfig eth0 up; ifconfig eth0 down; ifconfig eth0 hw ether 01:23:45:67:89:ab now my device was booting without obtaining an ip address, and there was no way to reach it. at least i thought so. then, i realized the needed a serial cable or another serial device to connect it. i didn’t have any cable, but i had a raspberry pi. using three female-female jumper wires, i connected ground (gnd), receive (rx) and transmit (tx) pins. the trick here is to connect rx pin of the raspberry pi to tx pin of the hmnhd-ce (and tx of r-pi to the rx pin). raspberrypi <-> hmnhd-ce gpio pin  6 <-> j4 pin 3 (gnd) gpio pin  8 <-> j4 pin 4 gpio pin 10 <-> j4 pin 2 using the raspberry pi, i opened a connection to serial console: after powering on the nas, i was able to see what is on the screen of the device, which does not have any output port for graphics. it is recently i have decided to switch to python installation from homebrew for easier management. in order to uninstall the python from package, you must remove the files and symbolic links to them. warning: this commands will remove all python versions installed with packages. python provided from the system will not be affected. you should also remember to remove the application folder, where x.y is the version number of your installation (ie. 2.7 or 3.4). öncesi 31 ocak – 3 şubat tarihleri arasında 4 gün boyunca ağ yönetimine giriş anlatıyor olacağız kişisel bilgisayarlarına centos 7 yükleyip gelmelerini bekliyoruz. katılımcılar bu yazıda anlatılanları adım adım uygulayarak bilgisayarınız üzerinde değişiklik yapmadan bir işletim sistemi yükleyebilmenizi sağlayan en pratik yöntem bir san*l bilgisayar